Sources: Boars Head, Sysco, Aldi. Employee Health Policy in place.
- Cooling Methods (corrected on site)
Observation: The methods used for cooling were not adequate.
Correction: Cool foods by the following methods: 1. Placing food in shallow pans 2. Separating food into smaller thinner portions 3. Using rapid chill cooling equipment 4. Stirring the food in a container placed in an ice water bath 5. Using containers that facilitate heat transfer 6. Adding ice as an ingredient 7. Any other method that can effectively accomplish cooling.
- Critical: Date Marking - Ready-to-Eat - Potentially Hazardous Food - Date Marking*
Observation: The prepared ready-to-eat (RTE) pasta, quiches and lunch meats in the refrigeration unit is not properly dated for disposition.
Correction: Mark the name and "consume by" date on the container of RTE foods at the time of preparation if the food is to be held for more than 24 hours. If the food is held at 41°F or below the food shall be served or sold within 7 calendar days. Some harmful bacteria continue to grow even at refrigeration temperatures so limiting the amount of time in storage limits the amount of growth allowed for these bacteria.
- Good Repair and Calibration of Thermometers (corrected on site)
Observation: Observed food thermometer is not calibrated to ensure accuracy
Correction: Calibrate food thermometer according to manufacturer's specification as necessary to ensure accuracy
|
08/13/2015 | Routine | |
All violations from previous inspection report have been corrected.
No violation noted during this evaluation. | 10/28/2014 | Follow-up | |
Manager stated that cleaning company was coming in on Oct. 23 for deep cleaning. Cutting surfaces had not been resurface/replaced and will be done before the 23rd. Manager stated that she would not use cutting surfaces until they had been resurfaced/replaced. Follow up visit scheduled for Oct. 24th.
- Equipment - Cutting Surfaces (repeated violation)
Observation: The cutting board(s) are heavily scratched and scored. The food contact surface is no longer easily cleaned and sanitized due to condition.
Correction: Resurface or discard and replace the cutting boards to provide a food contact surface that is smooth, easily cleaned and sanitized. Correct in 2 weeks
- Equipment - Food Contact Surfaces, Nonfood Contact Surfaces, and Utensils (repeated violation)
Observation: Observed accumulations of dust, dirt, food residue or other debris on the following nonfood-food contact surfaces: shelving where baking equipment is stored and hood filters.
Correction: Maintain nonfood-contact surfaces of equipment clean. Correct within 2 weeks
- Physical Facilities - Cleaning Frequency and Restrictions (repeated violation)
Observation: floors of the establishment noted in need of cleaning especially under equipment and shelving. Correct within 2 weeks
Correction: All floors, walls, and ceilings must be cleaned as often as necessary to keep them clean. Cleaning of the physical facilities is an important measure in ensuring the protection and sanitary preparation of food. A regular cleaning schedule should be established and followed to maintain the facility in a clean and sanitary manner.
|
10/08/2014 | Follow-up | |
- Critical: Demonstration of Knowledge* (corrected on site) (repeated violation)
Observation: The person in charge failed to state the required temperatures and holding times for the following conditions of potentially hazardous food: (1) Refrigerated storage, (2) Hot holding, (3) Cooling, and (4) Reheating.
Correction: Ensure the designated person in charge (PIC) is knowledgeable about foodborne disease prevention, Hazardous Analysis Critical Control Point principles and Regulation requirements. The PIC should be prepared to recognize conditions that may contribute to foodborne illness. The PIC must also recognize conditions that fail to comply with Regulation requirements and be authorized to take the appropriate preventive and corrective actions to ensure that the Regulations' objectives are fulfilled.
- Equipment - Cutting Surfaces
Observation: The cutting board(s) are heavily scratched and scored. The food contact surface is no longer easily cleaned and sanitized due to condition.
Correction: Resurface or discard and replace the cutting boards to provide a food contact surface that is smooth, easily cleaned and sanitized. Correct in 2 weeks
- Equipment - Food Contact Surfaces, Nonfood Contact Surfaces, and Utensils
Observation: Observed accumulations of dust, dirt, food residue or other debris on the following nonfood-food contact surfaces: shelving where baking equipment is stored and hood filters.
Correction: Maintain nonfood-contact surfaces of equipment clean. Correct within 2 weeks
- Physical Facilities - Cleaning Frequency and Restrictions (repeated violation)
Observation: floors of the establishment noted in need of cleaning especially under equipment and shelving. Correct within 2 weeks
Correction: All floors, walls, and ceilings must be cleaned as often as necessary to keep them clean. Cleaning of the physical facilities is an important measure in ensuring the protection and sanitary preparation of food. A regular cleaning schedule should be established and followed to maintain the facility in a clean and sanitary manner.
|
09/22/2014 | Routine | |
All issues from previous follow up inspection report have been corrected.
No violation noted during this evaluation. | 09/05/2013 | Follow-up | |
- Critical: Demonstration of Knowledge* (repeated violation)
Observation: The person in charge failed to state the required temperatures and holding times for the following conditions of potentially hazardous food: (1) Refrigerated storage, (2) Hot holding, (3) Cooling, and (4) Reheating.
Correction: Ensure the designated person in charge (PIC) is knowledgeable about foodborne disease prevention, Hazardous Analysis Critical Control Point principles and Regulation requirements. The PIC should be prepared to recognize conditions that may contribute to foodborne illness. The PIC must also recognize conditions that fail to comply with Regulation requirements and be authorized to take the appropriate preventive and corrective actions to ensure that the Regulations' objectives are fulfilled. Presented the manager with an information sheet on the above mentioned items.
- Critical: Equipment - Food Contact Surfaces, Nonfood Contact Surfaces, and Utensils* (repeated violation)
Observation: The following equipment food-contact surfaces were observed soiled to sight and touch: mold growth on inside of ice machine.
Correction: Clean and sanitize these surfaces for food contact. Correct today
- Equipment, Utensils, Linens, and Single-Service and Single-Use Articles (corrected on site) (repeated violation)
Observation: Clean utensils were observed stored with the food-contact surface facing upward.
Correction: Store equipment and utensils covered or inverted to prevent contamination while in storage.
- Lighting, Intensity (repeated violation)
Observation: Less than 20 foot candles of light was noted in the refrigeration units.
Correction: Provide at least 20 foot candles at a distance of 30 inches from the floor in consumer self-service areas, inside equipment, warewashing, equipment storage, toilet rooms
- Physical Facilities - Cleaning Frequency and Restrictions (repeated violation)
Observation: Floors of establishment noted in need of cleaning.
Correction: All floors, walls, and ceilings must be cleaned as often as necessary to keep them clean. Cleaning of the physical facilities is an important measure in ensuring the protection and sanitary preparation of food. A regular cleaning schedule should be established and followed to maintain the facility in a clean and sanitary manner.
|
08/21/2013 | Follow-up | |
- Critical: Demonstration of Knowledge*
Observation: The person in charge failed to state the required temperatures and holding times for the following conditions of potentially hazardous food: (1) Refrigerated storage, (2) Hot holding, (3) Cooling, and (4) Reheating.
Correction: Ensure the designated person in charge (PIC) is knowledgeable about foodborne disease prevention, Hazardous Analysis Critical Control Point principles and Regulation requirements. The PIC should be prepared to recognize conditions that may contribute to foodborne illness. The PIC must also recognize conditions that fail to comply with Regulation requirements and be authorized to take the appropriate preventive and corrective actions to ensure that the Regulations' objectives are fulfilled. Presented the manager with an information sheet on the above mentioned items.
- Critical: Hands - Preventing Contamination from Hands* (corrected on site)
Observation: Employees observed handling ready-to-eat (RTE) food with their bare hands.
Correction: Provide suitable utensils such as deli tissue, spatulas, tongs, single-use gloves, or dispensing equipment to handle RTE food to prevent contamination from hands.
- Cloths - Wiping Cloths - Use Limitation (corrected on site)
Observation: Wiping cloths improperly stored between use.
Correction: Ensure wet wiping cloths are stored in a chemical sanitizer at the proper concentration between use.
- Critical: Food - Potentially Hazardous Food - Cold Holding* (corrected on site)
Observation: chicken breast cold holding at improper temperatures
Correction: Relocate food to a refrigeration unit that is capable of maintaining food storage at 41°F or below.
- Critical: Warewashing - Manual & Mechanical Warewashing Equipment, Chemical Sanitization - Temperature, pH, Concentration & Hardness* (corrected on site)
Observation: Quaternary Ammonium sanitizing solution used was not at an acceptable concentration. Manager stated that they were out of sanitizer.
Correction: Adjust the sanitizing solution to 200 parts per million or otherwise identified by manufacturer's recommendations and use bleach as your sanitizer until quat. ammon sanitizer is replaced
- Critical: Equipment - Food Contact Surfaces, Nonfood Contact Surfaces, and Utensils*
Observation: The following equipment food-contact surfaces were observed soiled to sight and touch: mold growth on inside of ice machine.
Correction: Clean and sanitize these surfaces for food contact. Correct today
- Equipment, Utensils, Linens, and Single-Service and Single-Use Articles (corrected on site)
Observation: Clean utensils were observed stored with the food-contact surface facing upward.
Correction: Store equipment and utensils covered or inverted to prevent contamination while in storage.
- Lighting, Intensity
Observation: Less than 20 foot candles of light was noted in the refrigeration units.
Correction: Provide at least 20 foot candles at a distance of 30 inches from the floor in consumer self-service areas, inside equipment, warewashing, equipment storage, toilet rooms
- Physical Facilities - Cleaning Frequency and Restrictions (repeated violation)
Observation: Floors of establishment noted in need of cleaning.
Correction: All floors, walls, and ceilings must be cleaned as often as necessary to keep them clean. Cleaning of the physical facilities is an important measure in ensuring the protection and sanitary preparation of food. A regular cleaning schedule should be established and followed to maintain the facility in a clean and sanitary manner.
- Toxics - Presence and Use Restriction (corrected on site)
Observation: Unnecessary poisonous or toxic materials found in the food establishment. Roach killer not approved for restaurant use.
Correction: Remove unnecessary poisonous or toxic materials from the premises
|
08/14/2013 | Routine | |
Restaurant representatives - add corrected or new information about Radishes & Roses Cafe, 106 W Cameron St, Culpeper, VA 22701 »