- Critical: Hand Drying Provision
- Comment:
- CORRECTED BY PROVIDING PAPER TOWEL AT BAR HANDWASH SINK.
- General violation description:
- 6-301.12 - Each HANDWASHING SINK or group of adjacent HANDWASHING SINKS shall be provided with: (A) Individual, disposable towels
- Critical: Handwashing Cleanser, Availabi
- Comment:
- CORRECTED BY PROVIDING SOAP AT BAR HANDWASH SINK.
- General violation description:
- 6-301.11 - Each HANDWASHING SINK or group of 2 adjacent HANDWASHING SINKS shall be provided with a supply of hand cleaning liquid, powder, or bar soap.(Pf)
- Critical: Temperature Measuring Devices
- Comment:
- CORRECTED BY PROVIDING THERMOMETERS IN ALL COOLERS.
- General violation description:
- 4-204.112 - (A) In a mechanically refrigerated or hot FOOD storage unit, the sensor of a TEMPERATURE MEASURING DEVICE shall be located to measure the air temperature or a simulated product temperature in the warmest part of a mechanically refrigerated unit and in the coolest part of a hot FOOD storage unit. (B) Except as specified in # (C) of this section, cold or hot holding EQUIPMENT used for POTENTIALLY HAZARDOUS FOOD (TIME/TEMPERATURE CONTROL FOR SAFETY FOOD) shall be designed to include and shall be equipped with at least one integral or permanently affixed TEMPERATURE MEASURING DEVICE that is located to allow easy viewing of the device's temperature display. (C) Paragraph (B) of this section does not apply to EQUIPMENT for which the placement of a TEMPERATURE MEASURNG DEVICE is not a practical means for measuring the ambient air surrounding the FOOD because of the design, type, and use of the EQUIPMENT, such as calrod units, heat lamps, cold plates, bainmaries, steam tables, insulated FOOD transport containers, and salad bars. (D) TEMPERATURE MEASURING DEVICES shall be designed to be easily readable. (E) FOOD TEMPERATURE MEASURING DEVICES and water TEMPERATURE MEASURING DEVICES on WAREWASHING machines shall have a numerical scale, printed record, or digital readout in increments no greater than 1°C or 2°F in the intended range of use.(Pf)
- Cleaning, Frequency and Restri
- Comment:
- CORRECTED BY CLEANING THE WALK-IN COOLER.
- General violation description:
- 6-501.12 - (A) PHYSICAL FACILITIES shall be cleaned as often as necessary to keep them clean. (B) Except for cleaning that is necessary due to a spill or other accident, cleaning shall be done during periods when the least amount of FOOD is exposed such as after closing.
- Drying Mops
- Comment:
- CORRECTED BY INSTALLING THE MOP HANGER.
- General violation description:
- 6-501.16 - After use, mops shall be placed in a position that allows them to air-dry without soiling walls, EQUIPMENT, or supplies.
- Floor and Wall Junctures, Cove
- Comment:
- CORRECTED BY INSTALLING COVING.
- General violation description:
- 6-201.13 - (A) In FOOD ESTABLISHMENTS in which cleaning methods other than water flushing are used for cleaning floors, the floor and wall junctures shall be coved and closed to no larger than 1 mm (one thirty-second inch). (B) The floors in FOOD ESTABLISHMENTS in which water flush cleaning methods are used shall be provided with drains and be graded to drain, and the floor and wall junctures shall be coved and SEALED.
- Floors, Walls, and Ceilings
- Comment:
- CORRECTED BY INSTALLING ALL CEILING TILES.
- General violation description:
- 6-201.11 - Except as specified under # 6-201.14 and except for antislip floor coverings or applications that may be used for safety reasons, floors, floor coverings, walls, wall coverings, and ceilings shall be designed, constructed, and installed so they are SMOOTH and EASILY CLEANABLE.
- Good Repair and Proper Adjustm
- Comment:
- CORRECTED BY INSTALLING DRIP PAN.
- General violation description:
- 4-501.11 - (A) EQUIPMENT shall be maintained in a state of repair and condition that meets the requirements specified under Parts 4-1 and 4-2. (B) EQUIPMENT components such as doors, seals, hinges, fasteners, and kick plates shall be kept intact, tight, and adjusted in accordance with manufacturer's specifications. (C) Cutting or piercing parts of can openers shall be kept sharp to minimize the creation of metal fragments that can contaminate FOOD when the container is opened.
- Handwashing Signage
- Comment:
- CORRECTED BY PROVIDING SIGN AT BAR HANDWASH SINK.
- General violation description:
- 6-301.14 - A sign or poster that notifies FOOD EMPLOYEES to wash their hands shall be provided at all HANDWASHING SINKS used by FOOD EMPLOYEES and shall be clearly visible to FOOD EMPLOYEES.
|
01/23/2015 | Follow-up |
Restaurant representatives - add corrected or new information about Max & Erma's - Mce-Dtw. Llc Dba, Metro Airport - Mcnamara A, Gate A30, Romulus, MI 48242 »