- Critical: Eating, Drinking, or Using Tobacco* (corrected on site)
Observation: The cook is carrying a pack of cigarettes in an area other than designated break area while preparing/handling food or contacting clean food contact surfaces.
Correction: All personnel who are carrying tobacco must be in the designated break area away from food preparation/handling areas to prevent cross contamination.
- Critical: Hands - Preventing Contamination from Hands* (corrected on site)
Observation: Employees observed handling ready-to-eat (RTE) food with their bare hands.
Correction: Provide suitable utensils such as deli tissue, spatulas, tongs, single-use gloves, or dispensing equipment to handle RTE food to prevent contamination from hands.
- Utensils - In-Use - Between-Use Storage (corrected on site)
Observation: In-use utensils improperly stored between use.
Correction: Store in-use utensils or dispensing utensils in one of the following manners: 1) In the food with their handles above the top of the food and the container. 2) In food that is not potentially hazardous with their handles above the top of the food within containers or equipment that can be closed. 3) On a clean portion of the food preparation table or cooking equipment only if the in-use utensil and the food-contact surface of the food preparation table or cooking equipment are cleaned and sanitized every 4 hours. 4) In running water of sufficient velocity to flush particulates to the drain. 5) In a clean, protected location if the utensils are used only with a food that is not potentially hazardous. 6) In a container of water if the water is maintained at a temperature of at least 135°F.
- Nonfood-Contact Surfaces - Corrosion Resistant/Nonabsorbent (repeated violation)
Observation: The nonfood contact surface of the shelves in cooler and shelving in wait station and bricks for leg on freezer is not corrosion resistant, nonabsorbent, and/or smooth.
Correction: Nonfood contact equipment that is exposed to splash, spillage, food soiling, or requires frequent cleaning must be smooth, durable, and nonabsorbent.
- Non-Food Contact Surfaces (repeated violation)
Observation: The nonfood contact surface of the fryers,grills,seal at 3 compartment sink,and hose in floor has accumulations of grime and debris.
Correction: Clean the surface at a frequency necessary to preclude accumulation of soil residues that become encrusted or attract insects and rodents.
- Physical Facilities - Cleaning Frequency and Restrictions (repeated violation)
Observation: Floor in the kitchen noted in need of cleaning.
Correction: All floors, walls, and ceilings must be cleaned as often as necessary to keep them clean. Cleaning of the physical facilities is an important measure in ensuring the protection and sanitary preparation of food. A regular cleaning schedule should be established and followed to maintain the facility in a clean and sanitary manner.
|
10/27/2015 | Routine | |
- Critical: Food - Compliance with Food Law* (corrected on site)
Observation: Food prepared in a private home is distributed or offered for sale to the public.
Correction: Cease use of food prepared in a private home. Food must be obtained from an approved governmentally inspected food preparation/processing facility.
- Critical: Food - Potentially Hazardous Food - Cold Holding* (corrected on site) (repeated violation)
Observation: Steaks and raw hamburgers cold holding at improper temperatures
Correction: Relocate food to a refrigeration unit that is capable of maintaining food storage at 41°F or below or discard.
- Nonfood-Contact Surfaces - Corrosion Resistant/Nonabsorbent (repeated violation)
Observation: The nonfood contact surface of the counter edges is not corrosion resistant, nonabsorbent, and/or smooth.
Correction: Nonfood contact equipment that is exposed to splash, spillage, food soiling, or requires frequent cleaning must be smooth, durable, and nonabsorbent.
|
05/28/2015 | Routine | |
- Critical: Food - Potentially Hazardous Food - Cold Holding* (corrected on site)
Observation: Clams cold holding at improper temperatures
Correction: Discard the food and ensure that potentially hazardous foods for cold holding are maintained at 41°F or below to inhibit the growth of harmful bacteria.
- Non-Food Contact Surfaces (corrected on site) (repeated violation)
Observation: The nonfood contact surface of the hose has accumulations of grime and debris.
Correction: Clean the surface at a frequency necessary to preclude accumulation of soil residues that become encrusted or attract insects and rodents.
- Physical Facilities - Cleaning Frequency and Restrictions (repeated violation)
Observation: Floor in the kitchen noted in need of cleaning.
Correction: All floors, walls, and ceilings must be cleaned as often as necessary to keep them clean. Cleaning of the physical facilities is an important measure in ensuring the protection and sanitary preparation of food. A regular cleaning schedule should be established and followed to maintain the facility in a clean and sanitary manner.
|
10/31/2014 | Routine | |
- Non-Food Contact Surfaces
Observation: The nonfood contact surface of the table at fryers, and 3 compartment sink back has accumulations of grime and debris.
Correction: Clean the surface at a frequency necessary to preclude accumulation of soil residues that become encrusted or attract insects and rodents.
- Indoor Areas - Surface Characteristics (repeated violation)
Observation: The indoor ceiling material located at kitchen does not meet the standard of: 1. smooth, durable and easily cleanable 2. nonabsorbent
Correction: Refinish or replace the indoor ceiling at the area designated so it is: 1. smooth, durable and easily cleanable 2. nonabsorbent
|
05/14/2014 | Follow-up | |
- Food Storage - Clean and Dry Location
Observation: Food stored on the floor or food stored less than 6" above the floor.;Elevate food storage onto approved shelving with minimum 6" legs or casters.
- Nonfood-Contact Surfaces - Corrosion Resistant/Nonabsorbent (repeated violation)
Observation: The nonfood contact surface of the counter in service area and wait area,floor of walk-in cooler and door,and back of 3 compartment and back of stainless steel table near dishwasher is not corrosion resistant, nonabsorbent, and/or smooth.
Correction: Nonfood contact equipment that is exposed to splash, spillage, food soiling, or requires frequent cleaning must be smooth, durable, and nonabsorbent.
- Non-Food Contact Surfaces
Observation: The nonfood contact surface of the VULCAN oven,potatoe baker, grill trough,fryer exhaust,hose,light and chain in service area(heat lamp) has accumulations of grime and debris.
Correction: Clean the surface at a frequency necessary to preclude accumulation of soil residues that become encrusted or attract insects and rodents.
- Indoor Areas - Surface Characteristics
Observation: The indoor ceiling material located at kitchen does not meet the standard of: 1. smooth, durable and easily cleanable 2. nonabsorbent
Correction: Refinish or replace the indoor ceiling at the area designated so it is: 1. smooth, durable and easily cleanable 2. nonabsorbent
- Physical Facilities - Cleaning Frequency and Restrictions
Observation: Floor and coved tile in the kitchen noted in need of cleaning.
Correction: All floors, walls, and ceilings must be cleaned as often as necessary to keep them clean. Cleaning of the physical facilities is an important measure in ensuring the protection and sanitary preparation of food. A regular cleaning schedule should be established and followed to maintain the facility in a clean and sanitary manner.
|
05/08/2014 | Routine | |
- Nonfood-Contact Surfaces - Corrosion Resistant/Nonabsorbent
Observation: The nonfood contact surface of the door in kitchen is not corrosion resistant, nonabsorbent, and/or smooth.
Correction: Nonfood contact equipment that is exposed to splash, spillage, food soiling, or requires frequent cleaning must be smooth, durable, and nonabsorbent.
- Equipment - Good Repair and Proper Adjustment
Observation: Pump was observed in a condition that prevents necessary maintenance and easy cleaning.
Correction: Repair the pump to restore a state of condition that allows for proper operation, accuracy, functioning, maintenance, and cleanability per Part IV, Article 1 and 2 of this chapter. If unable to repair the @EQUIPMENT@, replace it with one that meets the specifications of Part IV, Article 1 and 2 of this chapter.
- Light Bulbs Protective Shielding (repeated violation)
Observation: Light bulb in kitchen not shielded, coated, or otherwise shatter-resistant.
Correction: Shield or replace light bulb with a coated or shatter-resistant bulb.
|
10/18/2013 | Routine | |
- Critical: Food - Potentially Hazardous Food - Cold Holding* (corrected on site)
Observation: Fish cold holding at improper temperatures
Correction: Relocate food to a refrigeration unit that is capable of maintaining food storage at 41°F or below.
- Light Bulbs Protective Shielding
Observation: Light bulb in kitchen not shielded, coated, or otherwise shatter-resistant.
Correction: Shield or replace light bulb with a coated or shatter-resistant bulb.
- Critical: Sanitizer - Criteria/Chemicals for food contact* (corrected on site)
Observation: Chlorine being applied to food contact surfaces does not meet the requirements of 40 CFR 180.940
Correction: Utilize only chlorine that meet the requirements of 40 CFR 180.940 when applying to food contact surfaces
|
05/02/2013 | Routine | |
Restaurant representatives - add corrected or new information about Harbor House, 912 East Main Street, Abingdon, VA 24210 »