Salad prep unit was operating at less than 41 F, with TCS foods at less than 41 F.
- Time/Temperature Control for Safety Food, Cold Holding (repeated violation)
Observation: Chicken pieces were observed at 44-46 F on right True 2 door prep unit for delivery.
Lettuce was at 44-46 F in left True 2 door prep unit for delivery.
Items removed. Call for service placed.
Correction: Except during preparation, cooking, or cooling, or when time is used as the public health control as specified under section 3-501.19, and except as specified under paragraph (B) of this section, time/temperature control for safety food shall be maintained at 5ºC (41ºF) or less. Bacterial growth and/or toxin production can occur if time/temperature control for safety food remains in the temperature "Danger Zone" of 5ºC to 57ºC (41ºF to 135ºF) too long. Up to a point, the rate of growth increases with an increase in temperature within this zone. Beyond the upper limit of the optimal temperature range for a particular organism, the rate of growth decreases. Operations requiring heating or cooling of food should be performed as rapidly as possible to avoid the possibility of bacterial growth.
- Equipment and Utensils, Air-Drying Required (repeated violation)
Observation: After cleaning and sanitizing, equipment and utensils are not air-dried, adequately drained, and/or they are cloth dried before contact with food.
Correction: After cleaning and sanitizing, equipment and utensils: (A) Shall be air-dried or used after adequate draining as specified in the first paragraph of 40 CFR 180.940 Tolerance exemptions for active and inert ingredients for use in antimicrobial formulations (food-contact surface sanitizing solutions), before contact with food
- Permit to Operate/Responsibilities of Permit Holder (repeated violation)
Observation: The 2016 permit is not posted in a location in the food establishment that is conspicuous to consumers.
Correction: Upon acceptance of the permit issued by the regulatory authority, the permit holder in order to retain the permit shall post the permit in a location in the food establishment that is conspicuous to consumers.
|
03/23/2016 | Follow-up | |
Follow up inspection to be conducted on or about 10 days to determine compliance.
- Package Integrity (corrected on site)
Observation: Heart of Palm cangood was observed severely dented on dry storage rack.
Correction: Food packages shall be in good condition and protect the integrity of the contents so that food is not exposed to adulteration or potential contaminants.
- Time/Temperature Control for Safety Food, Cold Holding (repeated violation)
Observation: Chicken pieces were observed at 44-46 F on right True 2 door prep unit for delivery.
Lettuce was at 44-46 F in left True 2 door prep unit for delivery.
Items removed. Call for service placed.
Correction: Except during preparation, cooking, or cooling, or when time is used as the public health control as specified under section 3-501.19, and except as specified under paragraph (B) of this section, time/temperature control for safety food shall be maintained at 5ºC (41ºF) or less. Bacterial growth and/or toxin production can occur if time/temperature control for safety food remains in the temperature "Danger Zone" of 5ºC to 57ºC (41ºF to 135ºF) too long. Up to a point, the rate of growth increases with an increase in temperature within this zone. Beyond the upper limit of the optimal temperature range for a particular organism, the rate of growth decreases. Operations requiring heating or cooling of food should be performed as rapidly as possible to avoid the possibility of bacterial growth.
- Equipment and Utensils, Air-Drying Required (repeated violation)
Observation: After cleaning and sanitizing, equipment and utensils are not air-dried, adequately drained, and/or they are cloth dried before contact with food.
Correction: After cleaning and sanitizing, equipment and utensils: (A) Shall be air-dried or used after adequate draining as specified in the first paragraph of 40 CFR 180.940 Tolerance exemptions for active and inert ingredients for use in antimicrobial formulations (food-contact surface sanitizing solutions), before contact with food
- Handwashing Sink/Using/Operation and Maintenance (corrected on site) (repeated violation)
Observation: The handwashing sink at the entrance to kitchen is used for purposes other than handwashing.
Correction: A handwashing sink may not be used for purposes other than handwashing. Sinks used for food preparation and warewashing can become sources of contamination if used as handwashing facilities by employees returning from the toilet or from duties which have contaminated their hands.
- Permit to Operate/Responsibilities of Permit Holder
Observation: The 2016 permit is not posted in a location in the food establishment that is conspicuous to consumers.
Correction: Upon acceptance of the permit issued by the regulatory authority, the permit holder in order to retain the permit shall post the permit in a location in the food establishment that is conspicuous to consumers.
|
03/09/2016 | Routine | |
- Food Storage Containers, Identified with Common Name of Food
Observation: Containers of bulk foods are not identified with the common name of the food.
Correction: Except for containers holding food that can be readily and unmistakably recognized such as dry pasta, working containers holding food or food ingredients that are removed from their original packages for use in the food establishment, such as cooking oils, flour, herbs, potato flakes, salt, spices, and sugar shall be identified with the common name of the food. Consumers may be allergic to certain foods or ingredients. The mistaken use of an ingredient, when the consumer has specifically requested that it not be used, may result in severe medical consequences. The mistaken use of food from unlabeled containers could result in chemical poisoning.
- Time/Temperature Control for Safety Food, Cold Holding (corrected on site)
Observation: Chicken pieces were observed at 49 F, sliced tomatoes were at 50 F, sliced beef was at 50 F in first Kaipak prep unit. Chicken pieces were at 48 F, sliced beef was at 53 F in second Kaipak prep unit. Cooked chicken pieces were at 50 F in left True 2 door delivery prep unit. Items removed from units. Call for immediate service was placed.
Correction: Except during preparation, cooking, or cooling, or when time is used as the public health control as specified under section 3-501.19, and except as specified under paragraph (B) of this section, time/temperature control for safety food shall be maintained at 5ºC (41ºF) or less. Bacterial growth and/or toxin production can occur if time/temperature control for safety food remains in the temperature "Danger Zone" of 5ºC to 57ºC (41ºF to 135ºF) too long. Up to a point, the rate of growth increases with an increase in temperature within this zone. Beyond the upper limit of the optimal temperature range for a particular organism, the rate of growth decreases. Operations requiring heating or cooling of food should be performed as rapidly as possible to avoid the possibility of bacterial growth.
- Equipment/Good Repair and Proper Adjustment
Observation: The #1 and #2 Kaipak prep units on the front line, and the left side True 2 door prep unit for delivery were not maintaining an internal ambient temperature of 41 F or less.
The 3 part sink table assembly was in need of being re-caulked to wall.
Correction: Equipment shall be maintained in a state of repair and condition that meets the requirements specified under Parts 4-1 [Materials for Construction and Repair] and 4-2 [Design and Construction]. Proper maintenance of equipment to manufacturer specifications helps ensure that it will continue to operate as designed. Failure to properly maintain equipment could lead to violations of the associated requirements of the Code that place the health of the consumer at risk. For example, refrigeration units in disrepair may no longer be capable of properly cooling or holding potentially hazardous (time/temperature control for safety) foods at safe temperatures.
- Sanitized/Hot Water and Chemical/Methods (corrected on site)
Observation: After being cleaned, equipment food-contact surfaces and utensils are not sanitized in a chemical manual or mechanical operations, using a proper solution. Third compartment was observed with zero parts per million of quaternary ammonium sanitizer. Compartment was emptied and re-filled with solution at 200 ppm.
Correction: After being cleaned, equipment food-contact surfaces and utensils shall be sanitized in chemical manual or mechanical operations, including the application of sanitizing chemicals by immersion, manual swabbing, brushing, or pressure spraying methods, using a solution as specified under section 4-501.114 by providing: (1) An exposure time of at least 10 seconds for a chlorine solution specified under paragraph 4-501.114(A), (2) An exposure time of at least 7 seconds for a chlorine solution of 50 mg/L that has a pH of 10 or less and a temperature of at least 38°C (100°F) or a pH of 8 or less and a temperature of at least 24°C (75°F), (3) An exposure time of at least 30 seconds for other chemical sanitizing solutions, or (4) An exposure time used in relationship with a combination of temperature, concentration, and pH that, when evaluated for efficacy, yields sanitization as defined in Subparagraph 1-201.10(B). Efficacious sanitization depends on warewashing being conducted within certain parameters. Time is a parameter applicable to both chemical and hot water sanitization. The time hot water or chemicals contact utensils or food-contact surfaces must be sufficient to destroy pathogens that may remain on surfaces after cleaning. Other parameters, such as rinse pressure, temperature, and chemical concentration are used in combination with time to achieve sanitization.
- Handwashing Sink/Using/Operation and Maintenance (corrected on site)
Observation: The handwashing sink located at the 3 part sink was observed with a container in the basin.
Correction: A handwashing sink shall be maintained so that it is accessible at all times for employee use. Facilities must be maintained in a condition that promotes handwashing and restricted for that use. Convenient accessibility of a handwashing facility encourages timely handwashing which provides a break in the chain of contamination from the hands of food employees to food or food-contact surfaces.
- Plumbing System/Maintained in Good Repair
Observation: The mop sink is hooked up to chemicals in a way that prevents dispensing of clean water only as an option.
The hot water supply at the 2 part prep sink is not functional.
Correction: A plumbing system shall be maintained in good repair. Improper repair or maintenance may result in the creation of obnoxious odors or nuisances, and may also adversely affect the operation of warewashing equipment or other equipment which depends on sufficient volume and pressure to perform its intended functions.
|
03/10/2015 | Routine | |
Facility uses an vegetable/fruit antimicrobial wash, which is located at the salad washing station. Good temperature control observed.
- Equipment, Food-Contact Surfaces, and Utensils (corrected on site)
Observation: Food debris observed on some food containers in the warewashing area that had been cleaned and sanitized.
Correction: Equipment food-contact surfaces and utensils shall be clean to sight and touch. The objective of cleaning focuses on the need to remove organic matter from food-contact surfaces so that sanitization can occur.
- Equipment and Utensils, Air-Drying Required
Observation: After cleaning and sanitizing, some pots and pans in the warewashing area were observed stacked while wet.
Correction: After cleaning and sanitizing, equipment and utensils: (A) Shall be air-dried or used after adequate draining as specified in the first paragraph of 40 CFR 180.940 Tolerance exemptions for active and inert ingredients for use in antimicrobial formulations (food-contact surface sanitizing solutions), before contact with food
|
03/11/2014 | Routine | |
- In-Use Utensils, Between-Use Storage
Observation: Food preparation and dispensing utensils are improperly stored. Spoon handles observed in direct contact with ready-to-eat foods on line prep refrigerators.
Correction: During pauses in food preparation or dispensing, food preparation and dispensing utensils shall be stored: (A) In the food with their handles above the top of the food and the container
- Food Storage, Prohibited Areas (corrected on site)
Observation: Chips, Breads and Croutons stored under front hand washing sink.
Correction: Relocate food storage to an approved area until the source of contamination is eliminated or removed.
|
04/26/2013 | Routine | |
Restaurant representatives - add corrected or new information about Chop't Creative Salad, 1735 N Lynn St, Arlington, VA 22209 »