- Temperature Measuring Devices (corrected on site) (repeated violation)
Observation: The temperature measuring device in the lowboy was not properly located in the warmest part of the unit.
Correction: Relocate the temperature measuring device to the warmest part of the refrigeration unit to properly represent the ambient air temperature.
- Handwashing - Using a Handwashing Lavatory - No Other Purpose (corrected on site)
Observation: The handwash station at the front prep area is being used to clean equipment and utensils.
Correction: The handwash facility identified above is to be used for washing hands only
|
03/02/2016 | Routine | |
Violations discussed and/ or corrected during inspection, food permit issued.
- Food Storage - Clean and Dry Location (corrected on site) (repeated violation)
Observation: Food stored on the floor or food stored less than 6" above the floor.;Elevate food storage onto approved shelving with minimum 6" legs or casters.
- Temperature Measuring Devices
Observation: The temperature measuring device in the small reach-in cooler was not properly located in the warmest part of the unit.
Correction: Relocate the temperature measuring device to the warmest part of the refrigeration unit to properly represent the ambient air temperature.
- Equipment - Good Repair and Proper Adjustment
Observation: The door gasket to the small reach-in cooler is in poor repair.
Correction: Repair or replace the door gasket in accordance with the manufacturer's specifications.
- Non-Food Contact Surfaces (repeated violation)
Observation: The nonfood contact surface of the cooler gasket has accumulations of grime and debris.
Correction: Clean the surface at a frequency necessary to preclude accumulation of soil residues that become encrusted or attract insects and rodents.
|
06/22/2015 | Routine | |
Violations discussed and/ or corrected during inspection, under new management, instructed new owner to change information in health department data base for proper credit.
- Food Storage - Clean and Dry Location (corrected on site) (repeated violation)
Observation: Food stored on the floor or food stored less than 6" above the floor.;Elevate food storage onto approved shelving with minimum 6" legs or casters.
- Critical: Equipment - Food Contact Surfaces, Nonfood Contact Surfaces, and Utensils* (corrected on site) (repeated violation)
Observation: The following equipment food-contact surfaces were observed soiled to sight and touch: fryer area, inside ref
Correction: Clean and sanitize these surfaces for food contact.
- Light Bulbs Protective Shielding (repeated violation)
Observation: Light bulb in hot holding unit not shielded, coated, or otherwise shatter-resistant.
Correction: Shield or replace light bulb with a coated or shatter-resistant bulb.
- Physical Facilities in Good Repair (repeated violation)
Observation: Walk-in freezer floor is not maintained in good repair
Correction: Maintain physical facilities in good repair. Poor repair and maintenance compromises the functionality of the physical facilities.
- Critical: Toxics - Storage of Toxic Containers* (corrected on site)
Observation: Containers of glass sanitizer are not properly stored to prevent the contamination of food, equipment, utensils, linens or single service items.
Correction: Containers of glass sanitizer must be located in an area that is not above food, equipment, utensils, linens or single service items.
|
12/10/2014 | Routine | |
Violations discussed and/ or corrected during inspection.
- Food Storage - Clean and Dry Location (repeated violation)
Observation: Food stored on the floor or food stored less than 6" above the floor.;Elevate food storage onto approved shelving with minimum 6" legs or casters.
- Critical: Equipment - Food Contact Surfaces, Nonfood Contact Surfaces, and Utensils* (corrected on site) (repeated violation)
Observation: The following equipment food-contact surfaces were observed soiled to sight and touch: inside reach-in cooler/shake machine.
Correction: Clean and sanitize these surfaces for food contact.
- Equipment - Non-Food Contact Surfaces and Utensils (repeated violation)
Observation: Surfaces of the ice machine was in contact with non-potentially hazardous food items that were observed soiled with accumulations of grime and debris.
Correction: Clean the surface of ice machine at any time when contamination may have occurred, at least every 24 hours, before restocking the consumer self-service equipment/utensils, or per manufacturer specifications.
- Non-Food Contact Surfaces (repeated violation)
Observation: The nonfood contact surface of the cooler gasket has accumulations of grime and debris.
Correction: Clean the surface at a frequency necessary to preclude accumulation of soil residues that become encrusted or attract insects and rodents.
- Physical Facilities in Good Repair
Observation: Freezer metal floor is not maintained in good repair
Correction: Maintain physical facilities in good repair. Poor repair and maintenance compromises the functionality of the physical facilities.
- Physical Facilities - Cleaning Frequency and Restrictions (corrected on site) (repeated violation)
Observation: Floor in the kitchen noted in need of cleaning.
Correction: All floors, walls, and ceilings must be cleaned as often as necessary to keep them clean. Cleaning of the physical facilities is an important measure in ensuring the protection and sanitary preparation of food. A regular cleaning schedule should be established and followed to maintain the facility in a clean and sanitary manner.
- Ventilation Systems - Cleaning Ventilation Systems - Nuisance and Discharge Prohibition
Observation: Intake and exhaust air ducts are not being cleaned
Correction: Clean intake and exhaust air ducts and change filters so they are not a source of contamination by dust, dirt and other materials
|
06/04/2014 | Routine | |
Violations discussed for correction.
- Temperature Measuring Devices
Observation: There was no temperature measuring device located in the reach-in cooler.
Correction: Provide a temperature measuring device in all hot or cold holding equipment used to store potentially hazardous foods so that employees can routinely monitor the ambient air temperature.
- Critical: Equipment - Food Contact Surfaces, Nonfood Contact Surfaces, and Utensils* (repeated violation)
Observation: The following equipment food-contact surfaces were observed soiled to sight and touch: inside milkshake cooler.
Correction: Clean and sanitize these surfaces for food contact.
- Equipment - Non-Food Contact Surfaces and Utensils (repeated violation)
Observation: Surfaces of the ice machine was in contact with non-potentially hazardous food items that were observed soiled with accumulations of grime and debris.
Correction: Clean the surface of ice machine at any time when contamination may have occurred, at least every 24 hours, before restocking the consumer self-service equipment/utensils, or per manufacturer specifications.
- Light Bulbs Protective Shielding
Observation: Light bulb in kitchen not shielded, coated, or otherwise shatter-resistant.
Correction: Shield or replace light bulb with a coated or shatter-resistant bulb.
- Toilet Rooms - Enclosed
Observation: Toilet room door is not tight fitting. and/or provided with a self- closing door
Correction: Provide toilet room door that is tight fitting. Completely enclosed toilet facilities minimize the potential for the spread of disease by the movement of flies and other insects between the toilet facility and food preparation areas.
|
12/02/2013 | Routine | |
Violations discussed for correction, Food permit issued.
- Food Storage Containers - Identified with Common Name of Food
Observation: Unlabeled food containers.
Correction: Label working containers with the common name of its contents. Consumers may be allergic to certain foods or ingredients. The mistaken use of an ingredient when the consumer has requested that it not be used may result in severe medical consequences. Liquid foods and granular foods may resemble cleaning compounds. The mistaken use of food from an unlabeled container could result in chemical poisoning.
- Utensils - In-Use - Between-Use Storage
Observation: Dispensing utensils improperly stored between uses.
Correction: Store in-use utensils or dispensing utensils in one of the following manners: 1) In the food with their handles above the top of the food and the container. 2) In food that is not potentially hazardous with their handles above the top of the food within containers or equipment that can be closed. 3) On a clean portion of the food preparation table or cooking equipment only if the in-use utensil and the food-contact surface of the food preparation table or cooking equipment are cleaned and sanitized every 4 hours. 4) In running water of sufficient velocity to flush particulates to the drain. 5) In a clean, protected location if the utensils are used only with a food that is not potentially hazardous. 6) In a container of water if the water is maintained at a temperature of at least 135°F.
- Food Storage - Clean and Dry Location (corrected on site)
Observation: Food stored on the floor or food stored less than 6" above the floor.;Elevate food storage onto approved shelving with minimum 6" legs or casters.
- Critical: Date Marking - Ready-to-Eat - Potentially Hazardous Food - Date Marking*
Observation: The prepared ready-to-eat (RTE) cheese in the refrigeration unit is not properly dated for disposition.
Correction: Mark the name and "consume by" date on the container of RTE foods at the time of preparation if the food is to be held for more than 24 hours. If the food is held at 41°F or below the food shall be served or sold within 7 calendar days. Some harmful bacteria continue to grow even at refrigeration temperatures so limiting the amount of time in storage limits the amount of growth allowed for these bacteria.
- Critical: Equipment - Food Contact Surfaces, Nonfood Contact Surfaces, and Utensils* (repeated violation)
Observation: The following equipment food-contact surfaces were observed soiled to sight and touch: shake machine.
Correction: Clean and sanitize these surfaces for food contact.
- Equipment - Non-Food Contact Surfaces and Utensils
Observation: Surfaces of the ice machine was in contact with non-potentially hazardous food items that were observed soiled with accumulations of grime and debris.
Correction: Clean the surface of ice machine at any time when contamination may have occurred, at least every 24 hours, before restocking the consumer self-service equipment/utensils, or per manufacturer specifications.
- Non-Food Contact Surfaces (repeated violation)
Observation: The nonfood contact surface of the ref gasket has accumulations of grime and debris.
Correction: Clean the surface at a frequency necessary to preclude accumulation of soil residues that become encrusted or attract insects and rodents.
- Handwashing - Using a Handwashing Lavatory - No Other Purpose
Observation: The handwash station at the kitchen is being used for purposes other than washing hands.
Correction: The handwash facility identified above is to be used for washing hands only
- Hand Drying Provision
Observation: No disposable towels were provided at the hand washing lavatory in the kitchen near 3 sink.
Correction: Hand drying devices such as individual disposable paper towels, a continuous towel system that supplies the user with a clean towel or heated air hand drying device must be provided at all hand washing lavatories to encourage proper hand washing and avoid employees to drying their hands on their clothing or other unclean materials
- Physical Facilities - Cleaning Frequency and Restrictions
Observation: Floor/wall in the kitchen noted in need of cleaning.
Correction: All floors, walls, and ceilings must be cleaned as often as necessary to keep them clean. Cleaning of the physical facilities is an important measure in ensuring the protection and sanitary preparation of food. A regular cleaning schedule should be established and followed to maintain the facility in a clean and sanitary manner.
- Critical: Toxics - Storage of Toxic Containers*
Observation: Containers of spray bottle are not properly stored to prevent the contamination of food, equipment, utensils, linens or single service items.
Correction: Containers of spray bottle must be located in an area that is not above food, equipment, utensils, linens or single service items.
|
06/04/2013 | Routine | |
Violations discussed and/ or corrected during inspection.
- Hands - Where to Wash
Observation: A food employee was observed cleaning their hands in a food preparation sink or a sink used for utensil washing.
Correction: Instruct food employees to clean their hands in a handwashing lavatory. Food employees may not clean their hands in a sink used for food preparation or utensil washing.
- Ventilation Hood System, Drip Prevention (corrected on site)
Observation: Grease from the exhaust hood system at the cook line was observed dripping onto food contact surfaces below.
Correction: Alter or replace the hood system to prevent grease or condensation from draining or dripping onto food, equipment, utensils, linens, single-service, and single-use articles.
- Critical: Equipment - Food Contact Surfaces and Utensils (corrected on site)
Observation: Food contact surfaces of the small prep cooler used to prepare/store potentially hazardous food items were observed soiled with accumulations of food residues.
Correction: Clean food-contact surfaces of small prep cooler no less than every 4 hours to prevent the growth microorganisms on those surfaces.
- Non-Food Contact Surfaces (repeated violation)
Observation: The nonfood contact surface of the cooler gasket has accumulations of grime and debris.
Correction: Clean the surface at a frequency necessary to preclude accumulation of soil residues that become encrusted or attract insects and rodents.
- Water Pressure (corrected on site)
Observation: Hot / Cold water under insufficient or inadequate pressure was found to serve the following equipment: hand sink
Correction: Inadequate water pressure could result in improper handwashing or equipment operation. Restore water under sufficient and adequate pressure to the hand sink immediately.
- Physical Facilities in Good Repair (corrected on site) (repeated violation)
Observation: Kitchen floor drain cover is not maintained in good repair
Correction: Maintain physical facilities in good repair. Poor repair and maintenance compromises the functionality of the physical facilities.
|
12/13/2012 | Routine | |
Restaurant representatives - add corrected or new information about Sonic Drive-In #4302 (01-1620), 3581 Holland Road, Virginia Beach, VA 23452 »