Kitchen floor surface under/around equipment noted in need of cleaning. The kitchen storage shelving was observed in need of cleaning. The reach-in freezer was observed in need of defrosting. Kitchen ceiling vent(s) were observed in need of cleaning. Chlorine sanitizer in the mechanical dishmachine checked for proper concentration using the provided test strips (50-100 ppm).
- Equipment, Food-Contact Surfaces, and Utensils (corrected on site)
Observation: Surfaces of the mechanical slicer were observed in need of cleaning and sanitizing.
Correction: Equipment food-contact surfaces and utensils shall be clean to sight and touch. The objective of cleaning focuses on the need to remove organic matter from food-contact surfaces so that sanitization can occur.
- Equipment/Cooking and Baking/Cleaning Frequency
Observation: Interior surface of the oven was observed in need of cleaning.
Correction: The cavities and door seals of microwave ovens shall be cleaned at least every 24 hours by using the manufacturer's recommended cleaning procedure. Food-contact surfaces of cooking equipment must be cleaned to prevent encrustations that may impede heat transfer necessary to adequately cook food. Encrusted equipment may also serve as an insect attractant when not in use. Because of the nature of the equipment, it may not be necessary to clean cooking equipment as frequently as the equipment specified in section 4-602.11.
- Poisonous or Toxic Materials/Separation/Spacing or Partitioning (corrected on site)
Observation: Chemical spray bottle(s) observed improperly stored on the shelving with the bottled sauces near the kitchen handsink area.
Correction: Poisonous or toxic materials shall be stored so they can not contaminate food, equipment, utensils, linens or single-service and single-use articles by separating the poisonous or toxic materials by spacing or partitioning. Separation of poisonous and toxic materials in accordance with the requirements of this section ensures that food, equipment, utensils, linen, and single-service and single-use articles are properly protected from contamination. For example, the storage of these types of materials directly above or adjacent to food could result in contamination of the food from spillage.
|
10/08/2015 | Risk Factor | |
If establishment chooses to pickle cucumbers/products as a method of food preservation, then the requirements of FDA Food Code 3-502.11 must be properly met. No pickles were observed being processed during inspection, but a sign was noticed indicating that the consumers could potentially request pickles for purchase and consumption.
- Equipment/Fixed, Spacing or Sealing
Observation: The caulking at the 3-compartment sink wall was observed in need of repair.
Correction: Equipment that is fixed because it is not easily movable shall be installed so that it is: (1) Spaced to allow access for cleaning along the sides, behind, and above the equipment
- Equipment/Good Repair and Proper Adjustment
Observation: The splashguards for the service sink were observed damaged and in need of repair.
Correction: Equipment shall be maintained in a state of repair and condition that meets the requirements specified under Parts 4-1 [Materials for Construction and Repair] and 4-2 [Design and Construction]. Proper maintenance of equipment to manufacturer specifications helps ensure that it will continue to operate as designed. Failure to properly maintain equipment could lead to violations of the associated requirements of the Code that place the health of the consumer at risk. For example, refrigeration units in disrepair may no longer be capable of properly cooling or holding potentially hazardous (time/temperature control for safety) foods at safe temperatures.
- Equipment, Food-Contact Surfaces, Nonfood-Contact Surfaces, and Utensils/Clean (corrected on site)
Observation: The container at the preparation station used to hold the single-service sauce cups was observed in need of cleaning and sanitizing. The surface underneath the preparation line cutting board was observed in need of cleaning and sanitizing.
Correction: Nonfood-contact surfaces of equipment shall be kept free of an accumulation of dust, dirt, food residue, and other debris. The objective of cleaning focuses on the need to remove soil from nonfood contact surfaces so that pathogenic microorganisms will not be allowed to accumulate and insects and rodents will not be attracted.
|
04/13/2015 | Routine | |
- Wiping Cloths, Use Limitation
Observation: Cloths in-use for wiping counters and other equipment surfaces are not held between uses in a chemical sanitizer solution of proper concentration
Correction: and/or not laundered daily.
- Food Storage/Preventing Contamination from the Premises
Observation: Food containers stored on the walk-in cooling unit floor.
Correction: Store food where it is not exposed to splash, dust, or other contamination and/or install an approved, durable and cleanable barrier between the splash source and the food to prevent contamination.
- Equipment Food-Contact Surfaces and Utensils/Time Temperature Control For Safety Food/Cleaning Frequency
Observation: The inside of the ice machine needs cleaning.
Correction: Except when dry cleaning methods are used as specified under section 4-603.11, surfaces of utensils and equipment contacting food that is not time/temperature control for safety food shall be cleaned: (1) At any time when contamination may have occurred
- Equipment/Nonfood-Contact Surfaces/Cleaning Frequency
Observation: The 3-part sink is moldy at the wall juncture.
Correction: Nonfood-contact surfaces of equipment shall be cleaned at a frequency necessary to preclude accumulation of soil residues. The presence of food debris or dirt on nonfood contact surfaces may provide a suitable environment for the growth of microorganisms which employees may inadvertently transfer to food. If these areas are not kept clean, they may also provide harborage for insects, rodents, and other pests.
- Physical Facilities/Repairing
Observation: The kitchen floor is damaged, (cracked) and the baseboards are loose.
Correction: Physical facilities shall be maintained in good repair. Poor repair and maintenance compromises the functionality of the physical facilities. This requirement is intended to ensure that the physical facilities are properly maintained in order serve their intended purpose.
- Drying Mops
Observation: After use, the mop is not placed in a position that allows it to air-dry without soiling walls, equipment, or supplies.
Correction: After use, mops shall be placed in a position that allows them to air-dry without soiling walls, equipment, or supplies. Mops can contaminate food and food preparation areas if not properly cleaned and stored after use. Mops should be cleaned and dried in a sanitary manner away from food flow areas.
|
10/23/2014 | Routine | |
- Equipment, Food-Contact Surfaces, and Utensils
Observation: The food-contact equipment surface of the smoker is not clean to sight and touch.
Correction: Equipment food-contact surfaces and utensils shall be clean to sight and touch. The objective of cleaning focuses on the need to remove organic matter from food-contact surfaces so that sanitization can occur.
|
12/23/2013 | Risk Factor | |
- Critical: Packaged and Unpackaged Food-Separation, Packaging, and Segregation/Preventing Food and Ingredient Contamination (corrected on site) (repeated violation)
Observation: Ready-to-eat food is not protected from cross contamination by separating them from raw animal foods. Raw eggs stored over butter in "True" 2-door counter refrigerator.
Correction: Food shall be protected from cross contamination by separating raw animal foods during storage, preparation, holding, and display from: (a) Raw ready-to-eat food including other raw animal food such as fish for sushi or molluscan shellfish, or other raw ready-to-eat food such as fruits and vegetables, and (b) Cooked ready-to-eat food.
- Critical: Potentially Hazardous Food, Cold Holding (corrected on site)
Observation: Packs of half-n-half (71F), Sliced cheese (47) and Sliced ham (46F) on "Superior" 3-door prep refrigerator.
Correction: (discarded) - Except during preparation, cooking, or cooling, or when time is used as the public health control as specified under section 3-501.19, and except as specified under paragraph (B) of this section, Potentially Hazardous Food (Time/Temperature Control for Safety Food) shall be maintained at 5ºC (41ºF) or less. Bacterial growth and/or toxin production can occur if potentially hazardous food (time/temperature control for safety food) remains in the temperature "Danger Zone" of 5ºC to 57ºC (41ºF to 135ºF) too long. Up to a point, the rate of growth increases with an increase in temperature within this zone. Beyond the upper limit of the optimal temperature range for a particular organism, the rate of growth decreases. Operations requiring heating or cooling of food should be performed as rapidly as possible to avoid the possibility of bacterial growth.
- Nonfood-Contact Surfaces
Observation: The nonfood-contact surface of the milk crates used for shelving is not free of unnecessary ledges, projections, and crevices, and/or designed and constructed to be easily cleanable or maintained.
Correction: Nonfood-contact surfaces shall be free of unnecessary ledges, projections, and crevices, and designed and constructed to allow easy cleaning and to facilitate maintenance. Hard-to-clean areas could result in the attraction and harborage of insects and rodents and allow the growth of foodborne pathogenic microorganisms. Well-designed equipment enhances the ability to keep nonfood-contact surfaces clean.
- Sanitizing Solutions, Testing Devices (corrected on site)
Observation: A test kit or other device that accurately measures the concentration of the sanitizing solution is not provided.
Correction: A test kit or other device that accurately measures the concentration in mg/L of sanitizing solutions shall be provided. Testing devices to measure the concentration of sanitizing solutions are required for 2 reasons: 1. The use of chemical sanitizers requires minimum concentrations of the sanitizer during the final rinse step to ensure sanitization
- Toilet Rooms, Enclosed
Observation: The toilet room is not completely enclosed and/or provided with a tight-fitting and/or self-closing door.
Correction: Except where a toilet room is located outside a food establishment and does not open directly into the food establishment such as a toilet room that is provided by the management of a shopping mall, a toilet room located on the premises shall be completely enclosed and provided with a tight-fitting and self-closing door. Completely enclosed toilet facilities minimize the potential for the spread of disease by the movement of flies and other insects between the toilet facility and food preparation areas.
|
03/11/2013 | Routine | |
Restaurant representatives - add corrected or new information about Cowboy Cafe, 4792 Lee Hwy, Arlington, VA 22207 »