Please register to participate in our discussions with 2 million other members - it's free and quick! Some forums can only be seen by registered members. After you create your account, you'll be able to customize options and access all our 15,000 new posts/day with fewer ads.
Any trick to cut such a bevel 45 angle without a circular saw and without a mitre box. Since there should be some trigonomentry formula to determine where the lines on the board should be located. Thanks
A coping saw and your own eyeballs...maybe also a speed square and a graphite pencil for marking the cut lines...but only if you're really, really good with the coping saw.
I have one of those and looking at it and how to use it for the bevel 45 not sure at the moment.
You don't see the numbers that go around the outside indicating the angle?
edited to add picture - hint note the angle is measured from the 0 line, not the edge, on this particular protractor. If you draw it from the edge, it's going to be a little off.
Last edited by Diana Holbrook; 04-24-2024 at 11:13 AM..
Please register to post and access all features of our very popular forum. It is free and quick. Over $68,000 in prizes has already been given out to active posters on our forum. Additional giveaways are planned.
Detailed information about all U.S. cities, counties, and zip codes on our site: City-data.com.