- Cooling Methods (corrected on site)
Observation: Observed foods cooling with tight covered lids.
Correction: Cooling shall be accomplished in accordance with the time and temperature criteria specified under section 3-501.14 by using one or more of the following methods based on the type of food being cooled: (1) Placing food in shallow pans
- Nonfood-Contact Surfaces
Observation: The nonfood-contact surfaces of the milk crates used for storage are not free of unnecessary ledges, projections, and crevices, and/or designed and constructed to be easily cleanable or maintained.
Correction: Nonfood-contact surfaces shall be free of unnecessary ledges, projections, and crevices, and designed and constructed to allow easy cleaning and to facilitate maintenance. Hard-to-clean areas could result in the attraction and harborage of insects and rodents and allow the growth of foodborne pathogenic microorganisms. Well-designed equipment enhances the ability to keep nonfood-contact surfaces clean.
- Equipment and Utensils, Air-Drying Required
Observation: After cleaning and sanitizing, equipment and utensils are not air-dried and/or adequately drained before contact with food.
Correction: After cleaning and sanitizing, equipment and utensils: (A) Shall be air-dried or used after adequate draining as specified in the first paragraph of 40 CFR 180.940 Tolerance exemptions for active and inert ingredients for use in antimicrobial formulations (food-contact surface sanitizing solutions), before contact with food
|
07/08/2015 | Routine | |
- Wiping Cloths, Use Limitation (corrected on site)
Observation: Containers of chemical sanitizing solutions in which wet wiping cloths are held between uses are not stored off the floor and/or in a manner that prevents contamination of food, equipment, utensils, linens, single-service, or single-use articles.
Correction: Containers of chemical sanitizing solutions in which wet wiping cloths are held between uses shall be stored off the floor and used in a manner that prevents contamination of food, equipment, utensils, linens, single-service, or single-use articles.
- Nonfood-Contact Surfaces/Nonabsorbent
Observation: The nonfood-contact surface of the milk crate used for shelving is not corrosion-resistant, nonabsorbent, and/or smooth.
Correction: Nonfood-contact surfaces of equipment that are exposed to splash, spillage, or other food soiling or that requires frequent cleaning shall be constructed of a corrosion-resistant, nonabsorbent, and smooth material. Nonfood-contact surfaces of equipment routinely exposed to splash or food debris are required to be constructed of nonabsorbent materials to facilitate cleaning. Equipment that is easily cleaned minimizes the presence of pathogenic organisms, moisture, and debris and deters the attraction of rodents and insects.
- Equipment/Good Repair and Proper Adjustment (repeated violation)
Observation: The door handle was in disrepair on the True 1 door uprt freezer creating a sharp edge.
Correction: Equipment shall be maintained in a state of repair and condition that meets the requirements specified under Parts 4-1 [Materials for Construction and Repair] and 4-2 [Design and Construction]. Proper maintenance of equipment to manufacturer specifications helps ensure that it will continue to operate as designed. Failure to properly maintain equipment could lead to violations of the associated requirements of the Code that place the health of the consumer at risk. For example, refrigeration units in disrepair may no longer be capable of properly cooling or holding potentially hazardous (time/temperature control for safety) foods at safe temperatures.
- Critical: Backflow Prevention, Air Gap
Observation: The diameter of the air gap between the water supply inlet and the flood level rim of the hose attached to mop sink faucet is less than 1 inch.
Correction: Provide an air gap with a diameter that is at least twice the diameter of the water supply inlet and not less than 1 inch for proper backflow prevention by the air gap.
- Refuse/Maintaining Refuse Areas and Enclosures
Observation: The storage area and/or enclosure for refuse, recyclables, or returnables is not maintained free of unnecessary items and/or clean. Grease observed on the ground on loading dock around grease receptacle used by establishment.
Correction: A storage area and enclosure for refuse, recyclables, or returnables shall be maintained free of unnecessary items, as specified under section 6-501.114, and clean. Proper storage and disposal of garbage and refuse are necessary to minimize the development of odors, prevent such waste from becoming an attractant and harborage or breeding place for insects and rodents, and prevent the soiling of food preparation and food service areas. Improperly handled garbage creates nuisance conditions, makes housekeeping difficult, and may be a possible source of contamination of food, equipment, and utensils.
|
08/22/2013 | Routine | |
Restaurant representatives - add corrected or new information about Popeye's Chicken & Biscuit, 1100 S Hayes St #108 & Cd-10, Arlington, VA 22202 »