- Jewelry Prohibition
Observation: An employee is wearing jewelry on his arm while preparing food.
Correction: Except for a plain ring such as a wedding band, while preparing food employees may not wear jewelry including medical information jewelry on their arms and hands.
- Food Storage/Preventing Contamination from the Premises
Observation: Food found store on the walk-in floor.
Correction: Food shall be protected from contamination by storing the food: (1) In a clean, dry location
- Food Display/Preventing Contamination by Consumers
Observation: Spices containers at the buffet table were not covered and not under the sneeze guards.
Correction: Except for nuts in the shell and whole, raw fruits and vegetables that are intended for hulling, peeling, or washing by the consumer before consumption, food on display shall be protected from contamination by the use of packaging
- Thawing
Observation: Thawing chicken and fish in standing water at the 3-part sink.
Correction: Time/temperature control for safety food shall be thawed: (A) Under refrigeration that maintains the food temperature at 5ºC (41ºF) or less
- Time/Temperature Control for Safety Food, Cold Holding (corrected on site)
Observation: Cut melons at 54-56 F, discarded.
Correction: Except during preparation, cooking, or cooling, or when time is used as the public health control as specified under section 3-501.19, and except as specified under paragraph (B) of this section, time/temperature control for safety food shall be maintained at 5ºC (41ºF) or less. Bacterial growth and/or toxin production can occur if time/temperature control for safety food remains in the temperature "Danger Zone" of 5ºC to 57ºC (41ºF to 135ºF) too long. Up to a point, the rate of growth increases with an increase in temperature within this zone. Beyond the upper limit of the optimal temperature range for a particular organism, the rate of growth decreases. Operations requiring heating or cooling of food should be performed as rapidly as possible to avoid the possibility of bacterial growth.
- Equipment and Utensils/Durability and Strength
Observation: The microwave, the two Kenmore cheat freezers and the Kenmore up-right freezer are not designed and constructed to be durable.
Correction: Equipment and utensils shall be designed and constructed to be durable and to retain their characteristic qualities under normal use conditions. Equipment and utensils must be designed and constructed to be durable and capable of retaining their original characteristics so that such items can continue to fulfill their intended purpose for the duration of their life expectancy and to maintain their easy cleanability. If they can not maintain their original characteristics, they may become difficult to clean, allowing for the harborage of pathogenic microorganisms, insects, and rodents. Equipment and utensils must be designed and constructed so that parts do not break and end up in food as foreign objects or present injury hazards to consumers. A common example of presenting an injury hazard is the tendency for tines of poorly designed single service forks to break during use.
- Temperature Measuring Devices
Observation: The Jordon two doors cooler, Kenmore chest and upright freezers are not equipped with at least one integral or permanently affixed temperature measuring device that is located to allow easy viewing of the device's temperature display.
Correction: Cold or hot holding equipment used for potentially hazardous food (time/temperature control for safety food) shall be designed to include and shall be equipped with at least one integral or permanently affixed temperature measuring device that is located to allow easy viewing of the device's temperature display. This section does not apply to equipment for which the placement of a temperature measuring device is not a practical means for measuring the ambient air surrounding the food because of the design, type, and use of the equipment, such as calrod units, heat lamps, cold plates, bainmaries, steamtables, insulated food transport containers, and salad bars. A permanent temperature measuring device is required in any unit storing potentially hazardous (time/temperature control for safety) food because of the potential growth of pathogenic microorganisms should the temperature of the unit exceed Code requirements. In order to facilitate routine monitoring of the unit, the device must be clearly visible.
- Equipment/Nonfood-Contact Surfaces/Cleaning Frequency
Observation: The kitchen hood needs cleaning.
Correction: Nonfood-contact surfaces of equipment shall be cleaned at a frequency necessary to preclude accumulation of soil residues. The presence of food debris or dirt on nonfood contact surfaces may provide a suitable environment for the growth of microorganisms which employees may inadvertently transfer to food. If these areas are not kept clean, they may also provide harborage for insects, rodents, and other pests.
- Cleaning, Frequency and Restrictions
Observation: The kitchen floor corners need cleaning.
Correction: Physical facilities shall be cleaned as often as necessary to keep them clean. Cleaning of the physical facilities is an important measure in ensuring the protection and sanitary preparation of food. A regular cleaning schedule should be established and followed to maintain the facility in a clean and sanitary manner.
|
12/07/2015 | Routine | |
Restaurant representatives - add corrected or new information about Hunan Gate Restaurant, 4233 N Fairfax Dr, Arlington, VA 22203-1606 »