- Critical: System Maintained in Good Repa
- Items:
- Plumbing system
- Problems:
- Not maintained
- Corrections:
- Maintain in good repair
- Comment:
- Observed restroom handsink faucets with timers shutting off after only 4 seconds. Timer faucets must run a minimum of 15 seconds before shutting off to allow adequate handwashing. Repair or replace the faucet timers.
- General violation description:
- 5-205.15 - A PLUMBING SYSTEM shall be: (A) Repaired according to LAW
- Hand Cleanser, Availabilty
- Items:
- Soap
- Problems:
- Not provided
- Corrections:
- Provide.
- Comment:
- Provide soap for dishroom handsink.
- General violation description:
- 6-301.11 - Each HANDWASHING SINK or group of 2 adjacent HANDWASHING SINKS shall be provided with a supply of hand cleaning liquid, powder, or bar soap.(Pf)
- Hand Drying Provision
- Items:
- Sanitary hand drying provisions
- Problems:
- Not provided
- Corrections:
- Provide.
- Comment:
- Provide paper towels for the dishroom handsink.
- General violation description:
- 6-301.12 - Each HANDWASHING SINK or group of adjacent HANDWASHING SINKS shall be provided with: (A) Individual, disposable towels
- Handwashing Signage
- Items:
- Handwashing signage
- Problems:
- Not provided
- Corrections:
- Provide.
- Comment:
- Provide a handwashing sign for the dishroom handsink.
- General violation description:
- 6-301.14 - A sign or poster that notifies FOOD EMPLOYEES to wash their hands shall be provided at all HANDWASHING SINKS used by FOOD EMPLOYEES and shall be clearly visible to FOOD EMPLOYEES.
- Maintaining/Using Handwashing
- Items:
- Handwashing facility
- Problems:
- Not accessible
- Corrections:
- Handwashing sinks are to be accessible for use at all times
- Comment:
- Observed container with utensils stored in the front counter handsink. Handsinks must be kept accessible. Store containers outside the handsink.
- General violation description:
- 6-501.18 - PLUMBING FIXTURES such as HANDWASHING SINKS, toilets, and urinals shall be cleaned as often as necessary to keep them clean.
- Preset Tableware
- Items:
- Preset tableware
- Problems:
- Not protected from contamination
- Corrections:
- Provide wrapped or dispense from an approved self-service dispenser.
- Comment:
- Observed forks and spoons dispensed in plastic trays where they are unprotected from contamination. Store these utensils in containers with handles up out of containers.
- General violation description:
- 4-904.13 - (A) Except as specified in # (B) of this section, TABLEWARE that is preset shall be protected from contamination by being wrapped, covered, or inverted. (B) Preset TABLEWARE may be exposed if: (1) Unused settings are removed when a CONSUMER is seated
- Temperature Measuring Devices
- Items:
- Thermometer(s)
- Problems:
- Not provided
- Corrections:
- Provide.
- Comment:
- Observed no thermometers in the Pinnacle and Pepsi coolers. Thermometers were provided in my presence. Violation corrected.
- General violation description:
- 4-204.112 - (A) In a mechanically refrigerated or hot FOOD storage unit, the sensor of a TEMPERATURE MEASURING DEVICE shall be located to measure the air temperature or a simulated product temperature in the warmest part of a mechanically refrigerated unit and in the coolest part of a hot FOOD storage unit. (B) Except as specified in # (C) of this section, cold or hot holding EQUIPMENT used for POTENTIALLY HAZARDOUS FOOD (TIME/TEMPERATURE CONTROL FOR SAFETY FOOD) shall be designed to include and shall be equipped with at least one integral or permanently affixed TEMPERATURE MEASURING DEVICE that is located to allow easy viewing of the device's temperature display. (C) Paragraph (B) of this section does not apply to EQUIPMENT for which the placement of a TEMPERATURE MEASURNG DEVICE is not a practical means for measuring the ambient air surrounding the FOOD because of the design, type, and use of the EQUIPMENT, such as calrod units, heat lamps, cold plates, bainmaries, steam tables, insulated FOOD transport containers, and salad bars. (D) TEMPERATURE MEASURING DEVICES shall be designed to be easily readable. (E) FOOD TEMPERATURE MEASURING DEVICES and water TEMPERATURE MEASURING DEVICES on WAREWASHING machines shall have a numerical scale, printed record, or digital readout in increments no greater than 1°C or 2°F in the intended range of use.(Pf)
|
09/06/2012 | Routine |
Restaurant representatives - add corrected or new information about Fairlane Club, 19401 Hubbard, Dearborn, MI 48126 »