- Critical. (A) Except as specified in Paragraph (D) of this section, refrigerated, ready-to-eat, potentially hazardous food prepared and held in a food establishment for more than 24 hours shall be clearly marked to indicate the date or day by which the food shall be consumed on the premises, sold, or discarded, based on the temperature and time combinations specified below: (1) 41 degrees Fahrenheit or less for a maximum of 7 days; The day of preparation shall be counted as Day 1.
- Critical. (A) In a mechanically refrigerated or hot food storage unit, the sensor of a temperature measuring device shall be located to measure the air temperature or a simulated product temperature in the warmest part of a mechanically refrigerated unit and in the coolest part of a hot food storage unit. (B) Except as specified in Paragraph (C) of this section, cold or hot holding equipment used for potentially hazardous food shall be designed to include and shall be equipped with at least one integral or permanently affixed temperature measuring device that is located to allow easy viewing of the device's temperature display. (C) Paragraph (B) of this section does not apply to equipment for which the placement of a temperature measuring device is not a practical means for measuring the ambient air surrounding the food because of the design, type, and use of the equipment, such as calrod units, heat lamps, cold plates, bainmaries, steam tables, insulated food transport containers, and salad bars. (D) Temperature measuring devices shall be designed to be easily readable. (E) Food temperature measuring device and water temperature measuring device on warewashing machines shall have a numerical scale, printed record, or digital readout in increments no greater than 2 degrees Fahrenheit in the intended range of use.
- Critical. Using a Handwashing Facility. (B) A handwashing facility may not be used for purposes other than handwashing.
- Good Repair and Proper Adjustment. (A) EQUIPMENT shall be maintained in a state of repair and condition that meets the requirements specified in Parts 4-1 and 4-2. (B) EQUIPMENT components such as doors, seals, hinges, fasteners, and kick plates shall be kept intact, tight, and adjusted in accordance with manufacturers' specifications. (C) Cutting or piercing parts of can openers shall be kept sharp to minimize the creation of metal fragments that can contaminate FOOD when the container is opened.
- Good Repair and Proper Adjustment. (A) EQUIPMENT shall be maintained in a state of repair and condition that meets the requirements specified in Parts 4-1 and 4-2. (B) EQUIPMENT components such as doors, seals, hinges, fasteners, and kick plates shall be kept intact, tight, and adjusted in accordance with manufacturers' specifications. (C) Cutting or piercing parts of can openers shall be kept sharp to minimize the creation of metal fragments that can contaminate FOOD when the container is opened.
- Cutting Surfaces. Surfaces such as cutting blocks and boards that are subject to scratching and scoring shall be resurfaced if they can no longer be effectively cleaned and sanitized, or discarded if they are not capable of being resurfaced.
- Critical. (C) Except as specified in Paragraph (D) of this section, if used with POTENTIALLY HAZARDOUS FOOD, EQUIPMENT FOOD-CONTACT SURFACES and UTENSILS shall be cleaned throughout the day at least every 4 hours. (D) Surfaces of utensils and equipment contacting potentially hazardous food may be cleaned less frequently than every 4 hours if: (1) In storage, containers of potentially hazardous food and their contents are maintained at temperatures specified under Chapter 3 and the containers are cleaned when they are empty; (2) Utensils and equipment are used to prepare food in a refrigerated room or area that is maintained at one of the temperatures in the following chart and: (a) The utensils and equipment are cleaned at the frequency in the following chart [temperature/cleaning frequency] that corresponds to the temperature: [at 41 degrees Fahrenheit or less - 24 hours; greater than 41 degrees Fahrenheit to 45 degrees Fahrenheit - 20 hours; greater than 45 degrees Fahrenheit to 50 degrees Fahrenheit - 16 hours; greater than 50 degrees Fahrenheit to 55 degrees Fahrenheit - 10 hours] (b) The cleaning frequency based on the ambient temperature of the refrigerated room or areas is documented in the food establishment. (3) Containers in serving situations such as salad bars, delis, and cafeteria lines hold ready-to-eat potentially hazardous food that is maintained at the temperatures specified under Chapter 3, are intermittently combined with additional supplies of the same food that is at the required temperature, and the containers are cleaned at least every 24 hours; (4) Temperature measuring devices are maintained in contact with food, such as when left in a container of deli food or in a roast, held at temperatures specified under Chapter 3; (5) Equipment is used for storage of packaged or unpackaged food such as a reach-in refrigerator and the equipment is cleaned at a frequency necessary to preclude accumulation of soil residues; (6) The cleaning schedule is approved based on consideration of: (a) Characteristics of the equipment and its use, (b) The type of food involved, (c) The amount of food residue accumulation, and (d) The temperature at which the food is maintained during the operation and the potential for the rapid and progressive multiplication of pathogenic or toxigenic microorganisms that are capable of causing foodborne disease; or (7) In-use utensils are intermittently stored in a container of water in which the water is maintained at 135 degrees Fahrenheit or more and the utensils and container are cleaned at least every 24 hours or at a frequency necessary to preclude accumulation of soil residues.
- Critical. (C) Except as specified in Paragraph (D) of this section, if used with POTENTIALLY HAZARDOUS FOOD, EQUIPMENT FOOD-CONTACT SURFACES and UTENSILS shall be cleaned throughout the day at least every 4 hours. (D) Surfaces of utensils and equipment contacting potentially hazardous food may be cleaned less frequently than every 4 hours if: (1) In storage, containers of potentially hazardous food and their contents are maintained at temperatures specified under Chapter 3 and the containers are cleaned when they are empty; (2) Utensils and equipment are used to prepare food in a refrigerated room or area that is maintained at one of the temperatures in the following chart and: (a) The utensils and equipment are cleaned at the frequency in the following chart [temperature/cleaning frequency] that corresponds to the temperature: [at 41 degrees Fahrenheit or less - 24 hours; greater than 41 degrees Fahrenheit to 45 degrees Fahrenheit - 20 hours; greater than 45 degrees Fahrenheit to 50 degrees Fahrenheit - 16 hours; greater than 50 degrees Fahrenheit to 55 degrees Fahrenheit - 10 hours] (b) The cleaning frequency based on the ambient temperature of the refrigerated room or areas is documented in the food establishment. (3) Containers in serving situations such as salad bars, delis, and cafeteria lines hold ready-to-eat potentially hazardous food that is maintained at the temperatures specified under Chapter 3, are intermittently combined with additional supplies of the same food that is at the required temperature, and the containers are cleaned at least every 24 hours; (4) Temperature measuring devices are maintained in contact with food, such as when left in a container of deli food or in a roast, held at temperatures specified under Chapter 3; (5) Equipment is used for storage of packaged or unpackaged food such as a reach-in refrigerator and the equipment is cleaned at a frequency necessary to preclude accumulation of soil residues; (6) The cleaning schedule is approved based on consideration of: (a) Characteristics of the equipment and its use, (b) The type of food involved, (c) The amount of food residue accumulation, and (d) The temperature at which the food is maintained during the operation and the potential for the rapid and progressive multiplication of pathogenic or toxigenic microorganisms that are capable of causing foodborne disease; or (7) In-use utensils are intermittently stored in a container of water in which the water is maintained at 135 degrees Fahrenheit or more and the utensils and container are cleaned at least every 24 hours or at a frequency necessary to preclude accumulation of soil residues.
- Critical. (E) Except when dry cleaning methods are used as specified under Section 4-603.11, surfaces of UTENSILS and EQUIPMENT contacting FOOD that is not POTENTIALLY HAZARDOUS shall be cleaned: (1) At any time when contamination may have occurred; (2) At least every 24 hours for iced tea dispensers and CONSUMER self-service UTENSILS such as tongs, scoops, or ladles; (3) Before restocking CONSUMER self-service EQUIPMENT and UTENSILS such as condiment dispensers and display containers; (4) In EQUIPMENT such as ice bins and BEVERAGE dispensing nozzles and enclosed components of EQUIPMENT such as ice makers, cooking oil storage tanks and distribution lines, BEVERAGE and syrup dispensing lines or tubes, coffee bean grinders, and water vending EQUIPMENT: (a) At a frequency specified by the manufacturer, or (b) Absent manufacturer specifications, at a frequency necessary to preclude accumulation of soil or mold.
- System Maintained in Good Repair. A PLUMBING SYSTEM shall be: (A) Repaired according to LAW; and (B) Maintained in good repair.
- Critical. Handwashing Signage. A sign or poster that notified FOOD EMPLOYEES' to wash their hands shall be posted at all handwashing lavatories used by FOOD EMPLOYEES' and shall be clearly visible to FOOD EMPLOYEES'.
- Critical. Hand Drying Provision. Each handwashing lavatory or group of adjacent lavatories shall be provided with: (A) Individual, disposable towels; (B) A continuous towel system that supplies the user with a clean towel; or (C) A heated-air hand drying device.
- Critical. Handwashing Cleanser, Availability. Each handwashing lavatory or group of 2 adjacent lavatories shall be provided with a supply of hand cleaning liquid, powder, or bar soap.
- Critical. (6) All building structural components, attachments and fixtures shall be kept in good repair, clean and free of obstructions.
- Surface Characteristics. (A) Except as specified in Paragraph (B) of this section, materials for indoor floor, wall, and ceiling surfaces under conditions of normal use shall be: (1) SMOOTH, durable, and EASILY CLEANABLE for areas where FOOD ESTABLISHMENT operations are conducted; (2) Closely woven and EASILY CLEANABLE carpet for carpeted areas; and (3) Nonabsorbent for areas subject to moisture such as FOOD preparation areas, walk-in refrigerators, WAREWASHING areas, toilet rooms, mobile FOOD ESTABLISHMENT SERVICING AREAS, and areas subject to flushing or spray cleaning methods. (B) In a TEMPORARY FOOD ESTABLISHMENT: (1) If graded to drain, a floor may be concrete, machine-laid asphalt, or dirt or gravel if it is covered with mats, removable platforms, duckboards, or other suitable APPROVED materials that are effectively treated to control dust and mud; and (2) Walls and ceilings may be constructed of a material that protects the interior from the weather and windblown dust and debris.
- (6) All building structural components, attachments and fixtures shall be kept in good repair, clean and free of obstructions.
- (d) Carbon dioxide and helium tanks shall be adequately secured so as to preclude any danger to safety.
- Critical. All managers employed by a food service establishment must have passed [the food service manager] test and received a certificate attesting thereto. Managers have a period of 30 days after employment to pass the required test. All managers who are responsible for the storage, preparation, display, and serving of foods to the public shall have passed a certification test approved by the division demonstrating a basic knowledge of food protection practices as adopted in this chapter. Those managers who successfully pass an approved certification examination shall be issued a certificate by the certifying organization, which is valid for a period of five years from the date of issuance. All public food service establishments must provide the division with proof of food service manager certification upon request...
- Critical. Food service employee training. The division shall adopt, by rule, minimum food safety protection standards for the training of all food service employees who are responsible for the storage, preparation, display, or serving of foods to the public in establishments regulated under this chapter. These standards shall not include an examination, but shall provide for a food safety training certificate program for food service employees to be administered by a private nonprofit provider chosen by the division. Any food safety training program established and administered to food handler employees prior to the effective date of this act shall be submitted by the operator to the division for its review and approval. It shall be the duty of the licensee of the public food service establishment to provide training in accordance with the described rule to all employees under the licensee's supervision or control. The licensee may designate a certified food service manager to perform this function as an agent of the licensee. Food service employees must receive certification pursuant to this section by January 1, 2001. Food service employees hired after November 1, 2000, must receive certification within 60 days after employment. Certification pursuant to this section shall remain valid for 3 years.
|
1/15/2010 | Routine - Food | Warning Issued |
Restaurant representatives - add corrected or new information about Pasta Grill, 17840 Front Beach Rd, Panama City Bch, FL »